Desander of Mud Treatment System

4. Desander

Desander  Desander_3D

Desander and desilter are solid control equipment with a set of hydrocyclones that separate sand and silt from the drilling fluids in drilling rigs.
Desanders are installed on top of the mud tank following the shale shaker and the degasser, but before the desilter. Desander removes the abrasive solids from the drilling fluids which cannot be removed by shakers.
Normally the solids diameter for desander to be separated would be 45~74μm, and 15~44μm for desilter.


Drive Principle Included in the Mud Desilter fine passing Cutting the Cyclone, Fine Screen removed through
Drive Effect Weighted Mud Barite without loss effectively removed from the Solid
Component Shaker, Cone, Mesh, Pipe etc.


Specification table of Desander (Woomin technology)

Treating Capacity 500GPM 1000GPM 1500GPM
Cone Size 10 inch 10 inch 10 inch
Cone Number 1 Each 2 Each 3 Each
Pressure 0.25 ~ 0.4 Mpa
Matching Pump 30 / 37 Kw 45 / 55 Kw 55 / 75 Kw
Separation 40 ~ 75 microns
Inlet Size 6 inch 6 inch 6 inch
Outlet Size 8 inch 8 inch 8 inch
Dimension 1618 x 1000 x 1900mm 1618 x 1000 x 1900mm 1618 x 1000 x 1900mm
Weight 430kg 490kg 550kg


Equipment Series of Mud Treatment System 

Share the Post

About the Author


No comment yet.

Leave a Reply

Your email address will not be published. Required fields are marked *